Saw Blade Change; Setting The Splitting Wedge Distance - HOLZMANN MASCHINEN TS 250F Mode D'emploi

14.1

saw blade change

CAUTION:
When installing saw blade change and always use protective gloves !
 The saw blade to max. Adjust the height.
 The 8 screws on the table insert Unscrew and remove the table insert.
 Fix the blade on the flange with the round pin with button.
 The bolt with a wrench from the shaft screws.
 Clean the motor spindle and flange thoroughly of impurities.
 Insert the blade with the correct direction of rotation on the motor spindle.
 Place the cleaned flange to the motor shaft.
 Screw the screw with washer back into the shaft and with wrench and round pin with button
-against turning sichern- tighten again.
NOTE: Observe direction of rotation arrow on the saw blade.
 Table insert reinsert and tighten the screws.

14.1.1 Setting the splitting wedge distance

 Unscrew easily screw A
 the riving knife b adjust to the distance of about 3-8mm.
 retighten screw A
 Replace cover and tighten
HOLZMANN MASCHINEN GmbH
Table insert
for using wrench
www.holzmann-maschinen.at
MAINTENANCE AND CARE
Round pin with button
54
TS 250F