Setting The Miter Angle; Setting The Depth Stop; Maintenance; Cutting - HOLZMANN MASCHINEN MKS 180 Mode D'emploi

13.2.4 Setting the miter angle

Loosen the clamping knob (8) by turning counterclockwise Figure K.
Turn the back stop (2) to the desired angle. This can be read on the scale.
Fig. K
Pull the cocking handle (8) by turning it clockwise again.
The front jaw pivots automatically in the intended position.

13.2.5 Setting the depth stop

Loosen the hex nut with a wrench 13th With an Allen wrench 8, you can set the appropriate
depth. Tighten the hex nut.
Fig. L

13.2.6 Cutting

Turn on the machine
Wait until the metal blade at full speed is.
Pull the saw head down gently and cut the material slowly.
Pull the saw head back to the starting position. Turn off the machine.
CAUTION: Check before cutting that the workpiece is tightened in a vice.
Use coolant when cutting !
Otherwise, the life of the saw blade reduces.
14

MAINTENANCE

Perform all maintenance machine settings with the machine
being disconnected from the power supply!
Serious injury due to unintentional or automatic activation of
the machine!
The machine is low maintenance and contains little parts that must undergo a maintenance
operator.
Faults or defects that may affect the safety of the machine can be immediately side.
Repair work may only be performed by qualified personnel!
HOLZMANN MASCHINEN GmbH
Fig. L.
N O T E
A T T E N T I O N
www.holzmann-maschinen.at
MAINTENANCE
20
MKS180