Assembly; Preparatory Activities; Workplace; Preparation Of The Surface - HOLZMANN MASCHINEN TS 250F Mode D'emploi

 Risk of injury to the eye by flying debris, even with goggles.
 Risk due to inhalation of toxic dust in chemically treated wood Workpieces.
These risks can be minimized if all safety rules are applied, the machine is properly maintained
and serviced the machine as intended and is serviced by a trained service professional. Despite
all the safety devices and remains her good common sense and your appropriate technical qualifi-
cation / training on the operation of a machine such as the sliding Panel saw TS 250F is the most
important safety factor!
12

ASSEMBLY

12.1

Preparatory activities

12.1.1 Scope of delivery
After receipt of the delivery, if all parts are in order. Report any damage or missing items imme-
diately to your dealer or the shipping company. Visible damage must also be recorded without
delay in accordance with the provisions of the warranty on the delivery, otherwise the goods shall
be accepted as properly.
content:
Base frame, rip fence guide rail, blade guard with suction, suction hose, stop, boom, ruler, push
stick, tilt stop on the ruler, edging shoe, extension table back, broadening table, assembly tool,
switch-plug combination, round pin with button.

12.1.2 Workplace

Choose a suitable place for the machine. Observe the safety requirements and the dimensions of
the machine.
The selected location must ensure as well as the possibility for connection to an extraction system
a suitable connection to the electrical grid.
Make sure that the floor can support the weight of the machine. The machine must be leveled on
all bases simultaneously.
You must also secure around a distance of at least 0.8 m around the machine. Before and behind
the machine must be provided the necessary distance for the supply of long workpieces.

12.1.3 Preparation of the surface

Eliminate the preservative, which is applied for corrosion protection of the parts without painting.
This can be done with the usual solvents. Here no nitro solvent or similar means, and in no case
use water.
The use of paint thinners, gasoline, corrosive chemicals or abrasive cleaners will result in
damage to the surface!
Therefore:
When cleaning, use only mild detergent
12.2

Mounting

The sliding table saw is delivered pre-assembled. Sliding table, boom, broadening table, rip fence
and saw blade guard must be mounted.
HOLZMANN MASCHINEN GmbH
N O T E
www.holzmann-maschinen.at
ASSEMBLY
45
TS 250F