Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
15.2
Operation
CLEANING, MAINTENANCE, STORAGE, DISPOSAL
Danger due to electrical voltage!
Handling the machine with connected power supply may result in serious injury or
death.
Always disconnect the machine from the power supply before maintenance or
repair work and secure it against unintentional reconnection.
16.1
Cleaning
Regular cleaning guarantees the long service life of your machine and is a prerequisite for its safe
operation.
Incorrect cleaning products can attack the finish of the machine. Do not use any
solvents, nitro thinners or other cleaning products that could damage the machine's
finish.
Observe the specifications and instructions of the cleaning agent manufacturer.
Remove chips and dirt particles from the machine after each use with a proper tool.
•
•
Prepare the surfaces and lubricate the bare machine parts with an acid-free lubricating oil
(e.g. WD40 rust inhibitor).
16.2
Maintenance
The machine is low-maintenance and only a few parts need to be serviced. Malfunctions or defects
that could affect your safety must be repaired immediately!
Before each operation, check the perfect condition of the safety devices.
•
Regularly check the perfect and legible condition of the warning and safety labels of the
•
machine.
Use only original spare parts recommended by the manufacturer.
•
Maintenance plan
The type and degree of machine wear depends to a large extent on the operating conditions. The
following intervals apply when the machine is used within the technical limits:
Interval
Before usage
HOLZMANN Maschinen GmbH
WAR N I N G
Components
Band wheel bearing
Blade guide bearing
Log screws
www.holzmann-maschinen.at
CLEANING, MAINTENANCE, STORAGE, DISPOSAL
• Place a log onto the track and secure it with the
log assembled supports.
• Press the ON button.
• Wait until saw blade reaches maximum speed.
• Turn on the lubrication.
• Set desired cutting height.
• Slide saw head slowly over the track.
• Turn off the machine after completing operation
with the OFF-button.
N O TE
Check for wear and if necessary replace it
Check for wear and if necessary replace it
Grease threads
Action
BBS810SMART_400V
44
Publicité
Table des Matières
