Saw Blade Height Adjustment; Setting Interface / Tilt Angle Blade; Setting The Cutting Width / Length; Instructions For Use - HOLZMANN MASCHINEN TS 250F Mode D'emploi

13.2.1 Saw blade height adjustment

To adjust the height of the saw blade to the material it
is adjusted with the handwheel A.
The handwheel A clockwise to the blade upward to lift.
Rotate left lower to it.
The blade should protrude about 5 mm from the work-
piece.

13.2.2 Setting interface / tilt angle blade

 The clamping screw for locking screw.
 To the saw blade from the inclination 90° - 45° is
the handwheel B . -Fig.3-
 The clamping screw afterwards retighten.

13.2.3 Setting the cutting width / length

The cutting length can be set on the rip fence guide so that these can
be read on the measuring scale. With the clamping screw, the rip
fence can be fixed.
13.3

Instructions for use:

13.3.1 Notes on using the panel saw

 Make sure you install the saw blade protection.
 Run the workpiece evenly without flare-ups and without take it back until the end of cutting to.
 Set the panel saw blade so high that the ring gear is really reliably covered by the panel saw
blade protection (distance between the panel saw blade guard and workpiece
(max. -. 5 mm )
WARNING: Perform the setup of the panel saw blade height and tilt by only with the machine
switched off.
For cuts less than 120 mm width supplying the mate-
rial with a push stick must be made, and the stop bar
must be in a flat position.
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
clamping screw
A B
OPERATION
Fig. 3
52
TS 250F