Operation; Adjustments Before Initial; Setting The Riving Knife; Saw Blade Start / Stop - HOLZMANN MASCHINEN TS 250F Mode D'emploi

13

OPERATION

13.1

Adjustments before initial

 Before any adjustments, the machine must be disconnected from the power supply to avoid
the risk of accidental switching on the machine!
 Check that the set speed for the saw blade used is not too high.
 Span only saw blades with a diameter of 250 mm.

13.1.1 Setting the riving knife

 Remove the blade guard cover from the riving knife
 The 8 screws of the table insert (a) remove and remove it. -Fig.1-
 Loosen the screw (a) and the riving knife (b) at a distance of about
3mm - 8mm adjust the saw blade. -Fig. 2-
 The riving knife can be preset with the grub screw c .
 Pull the riving knife with the screw (a) firmly.
 Attach the blade guard cover back on the riving knife.
NOTE: This procedure should be repeated every time the when the saw blade is replaced.
OPERATION
13.2

Saw blade start / stop

If you want to press the ON OFF switch, the combined
EMERGENCY STOP switch must be in the open state.
 To start, press the green button ˝ I ˝
 To start, press the red button ˝ O ˝
INFO: In the closed state of the main switch can be operated as an EMERGENCY STOP switch.
HOLZMANN MASCHINEN GmbH
Fig. 1
www.holzmann-maschinen.at
OPERATION
Fig. 2
C
51
TS 250F