Assembly Sliding Table - HOLZMANN MASCHINEN TS 250F Mode D'emploi

ASSEMBLY

12.2.1 Assembly sliding table

Unpack the sliding table from the box and place it on the marked in the following picture with A
Rec. Make sure that the sliding table will fit into the rectangular receptacle B and then tighten the
clamp screws on both sides of C.
ATTENTION!
The sliding table support has to be fixed in a defined position. For this purpose, it must be en-
sured that the safety switch locks into the recess hole A. If the safety switch does not lock into
the recess, the machine can be started for safety reasons only in jog mode.
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at 46
TS 250F