Operation; Operating Notes - HOLZMANN MASCHINEN HBS 300J Mode D'emploi

17

OPERATION

17.1 Operating notes

Perform all machine settings with the machine being
TAKE ATTENTION when cutting long workpieces without
additional support!
Hazard of machine damage and injuries through upbouncing
workpiece.
Therefore: always support long overhanging workpieces additionally
Let the engine run full speed when you begin to cut a work a
workpiece
Important! After every new adjustment we recommend you to make a trial cut
in order to check the new settings.





17.2 Operation
ON/OFF switch (Fig. 19)
 To turn the saw on, press the green button (g).
 To turn the saw off again, press the red button (h).
Your bandsaw has a switch with undervoltage release. After a power failure you must reactivate the
switch
Parallel stop (Fig. 21)
The parallel stop is used as a guide in slitting.
 Place the parallel stop (23) onto the chain bar (2) on the left or right and set the desired dimension.
 Clamp the parallel stop in the desired position by turning the fixing lever (27)
HOLZMANN MASCHINEN GmbH
W A R N I N G
disconnected from the power supply!
For all cutting operations it is important to position the blade guide (11)
as close as possible to the workpiece.
Always guide the workpiece with both hands, holding it flat on the table
(15) in order to prevent the blade (25) from jamming.
Feed the workpiece at a uniform speed that enables the blade to cut
through the material without difficulty and without blocking.
Always aim at making a complete cut in one pass rather than in a stop-
and-go operation requiring the workpiece to be withdrawn. If you have to
withdraw the workpiece, switch off the bandsaw first and wait for the
blade (25) to stop before freeing the workpiece.
The workpiece must always be guided by the longer side during
cutting.
www.holzmann-maschinen.at
A T T E N T I O N
N O T I C E
OPERATION
36
HBS 300J