Operation Instructions; Operation - HOLZMANN MASCHINEN DKS 21PRO Manuel D'utilisation

1
14

OPERATION

Device to be operated in a perfect state only. Inspect the device visually every time it is to be
used. Check in particular the safety equipment, electrical controls, electric cables and screwed
connection for damage and if tightened properly. Replace any damaged parts before operating
the device.
14.1

Operation instructions

Perform all machine settings with the machine being
disconnected from the power supply!
Check the saw blade to tight fit and free run

Do not cut small workpieces which can not safely hold by hand

 Do not start the machine when the workpiece is touching the saw
blade
Clamp the saw blade always so that the teeth point towards

worktable
The teeth cut the workpiece only during the downward stroke

Guide the workpiece slowly into the blade

During cutting of thick workpieces is of particular note that the

blade is not bent or twisted.
Check the to be cut workpiece for foreign objects as nails and

screws.
14.2 Operation
On/Off switch:
Push green button (I): On
Push red button (0): Off
Speed controller:
With the cutting speed controller (1), the stroke
rate can be set according to the material to be cut.
Setting worktable angle:
Loosen table tilt fixing knob (1). Set worktable to desired angle and retighten the table tilt fixing
knob.
HOLZMANN MASCHINEN GmbH
WARNING
www.holzmann-maschinen.at
NOTICE
.
PREFACIO
Página 26
DKS 21PRO