Operation; Operation Instructions; Table Adjustment - HOLZMANN MASCHINEN TK 255 Manuel D'utilisation

OPERATION

15 OPERATION
Device to be operated in a perfect state only. Inspect the device visually every time it is to be
used. Check in particular the safety equipment, electrical controls, electric cables and screwed
connection for damage and if tightened properly. Replace any damaged parts before operating
the device.
15.1

Operation instructions

Perform all machine settings with the machine being
disconnected from the power supply!
 Operating only with started dust collector!
 Never start the machine when the workpiece is pressed to the saw
blade!
Before starting the machine check if the saw blade is tightened

Always adapt cutting speed to the respective working

Use the push stick to avoid the risk of contact with the saw blade

Slide the workpiece evenly, without relapses and without retake it

until the end of cutting.
15.2

Table adjustment

HOLZMANN MASCHINEN GmbH
WARNING
www.holzmann-maschinen.at
NOTICE
1.Remove tool box
2.Loosen the following
screws (see pictures)
3. Adjust the work
table. Grooves must
run parallel to the saw
blade
4. tighten screws again
TK 255
32