Bevel Cut; Operation Modes; Miter Cuts; Sliding Cuts - HOLZMANN MASCHINEN KAP 305ECO Mode D'emploi

14.3.5 Bevel cut

Release the vertical angle lock (1) and pull out lock knob
(2). Set the desired angle. Tighten the vertical angle lock.

14.4 Operation modes

14.4.1 Miter cuts

 Ideal for cutting short workpieces in miter and/or bevel angles.
 For miter cuts fix the saw unit on the sliding bars with drag lock.
 Place the material to the fence and fix the material additionaly with the downholder.
 Prepare to cut and perform the cutting operation.
 Swing the saw unit back up, release the accelerator lever and wait until the electric saw brake
stops the saw.
 Now you can take the workpiece away

14.4.2 Sliding cuts

 Sliding cuts are ideal for performing longer cuts
 Fix the material!
 Pull the saw towards your body (drag lock open).
 Switch the machine on, wait until saw blade reaches full speed.
 Now swing the saw arm down and let it work its way slowly through the material. Now push
the saw arm slowly backwards.
Advantage: If the material cracks or material parts are catapulted, then not towards the operator.
Disadvantage: You MUST fix workpiece additionaly with downholder to prevent it from kickback.

14.4.3 Slot cuts

 Adjust the cutting depth for slut cuts as desired.

MAINTENANCE

Perform all maintenance machine settings with the machine being
disconnected from the power supply!
Serious injury due to unintentional or automatic activation of the
machine!
The machine does not require extensive maintenance. If malfunctions and defects occur, let it be
serviced by trained persons only.
Before first operation as well as later on every 100 operation hours you should lubricate all
connecting parts (if required, remove beforehand with a brush all swarfs and dust).
Check regularly the condition of the security stickers. Replace them if required.
Check regularly the condition of the machine.
The good condition and perfect adjustment is essential for a smooth and a clean cut.
Store the machine in a closed, dry location.
Clean your machine regularly after every usage – it prolongs the machines lifespan and is a pre-
requisite for a safe working environment.
Repair jobs shall be performed by respectively trained professionals only!

15.1 Maintenance plan

Loose or lost screws
Damage of any part
Saw blade condition
Clean machine
Empty dust bag
Readjust miter and bevel angle, laser;
Sharpen saw blade
Change saw blade
Change carbon brush
Belt tension
HOLZMANN MASCHINEN GmbH
A T T E N T I O N
N O T I C E
www.holzmann-maschinen.at
Prior to every operation
Prior to every operation
Prior to every operation
After every operation
After every operation
monthly
When necessary
When worn or defect
When carbon brush is worn ( < 4mm )
monthly
MAINTENANCE
29
KAP 305ECO