Operation; Switch On & Prepare To Cut; Switch Off; Operation Modes - HOLZMANN MASCHINEN KAP 305JL Mode D'emploi

14.3

Operation

14.3.1 Switch on & prepare to cut
 Connect the machine to the power supply
 Read, understand and apply the security instructions.
 Operate the accelerator lever (24) and wait until the saw blade has reached its full speed.
 With the forefinger you now push the security lock lever to the left to unlock the moveable
saw blade protection (25).

14.3.2 Switch off

As soon as you release the accelerator knob (24), the motor stops and the saw blade stops within
5-8 seconds.
14.4

Operation modes

14.4.1 Miter cuts

 Ideal for cutting short workpieces in miter and/or bevel angles.
 For miter cuts fix the saw arm on the sliding bars with fixing knob (22).
 Place the material to the back fence (1) and fix the material additionaly with the
downholder (10).
 Prepare to cut according to 5.1, perform the cutting operation.
 Swing the saw arm back up, release the accelerator lever and wait until the electric saw
brake stops the saw.
 Now you can take the workpiece away

14.4.2 Sliding cuts

 Sliding cuts are ideal for performing longer cuts
 Fix the material!
 Pull the saw towards your body.
 Switch the machine on, wait until saw blade reaches full speed.
 Now swing the saw arm down and let it work its way slowly through the material. Now
push the saw arm slowly backwards.
Advantage: If the material cracks or material parts are catapulted, then not towards the operator.
Disadvantage: You MUST fix workpiece additionaly with downholder (10) to prevent it from
kickback.

14.4.3 Slot cuts

 Clap the depth stop (27) to the side so that the adjustment screw (29) touches the depth
stop (27) when swinging down the saw arm.
 Adjust the adjustment screw for slut cuts as desired (29).
14.5

OPERATION NOTICES

 Always use well sharpened saw blades. Deflected, cracked or worn saw blades are a
security risk and have to be replaced immediately!
 Assure yourself that you do not overload the machine. Use it for operations it is designed
for.
 Choose always saw blades where at least 2-3 teeth are simultaneously in the material to
achieve a clean cut and to reduce the risk of material kickback.
 For precision miter and bevele cuts you should use a saw blade with at least 60 teeth.
HOLZMANN Maschinen GmbH www.holzmann-maschinen.at
KAP 305JL
All manuals and user guides at all-guides.com
OPERATION
43