Adjusting Touch-Sensitivity And Buzzer Volume - Dentsply Sirona CEREC Primescan AC Notice D'utilisation

5 Operation
5.1 Working with the touch monitor
48
5.1.3

Adjusting touch-sensitivity and buzzer volume

The CEREC Primescan AC / Primescan AC / CEREC Omnicam AC /
Omnicam AC provides you with the following options:
● Adjusting the touch-sensitivity of the touchpad/trackball buttons
● Adjusting the volume for their acoustic feedback
1. To do this, go to the taskbar and click on the arrow pointing
upwards.
2. Click the icon for freezing the monitor.
3. Slide the controller for touch-sensitivity to the right or left to set the
touch-sensitivity to your preference.
4. Slide the volume controller to the right or left. The volume can be
adjusted between 0 (low) and 100 (high).
Tip: If you want to stick the icon for freezing the monitor, and the
associated functionality for the settings, onto the taskbar, then press on
the icon, pull it over the taskbar and then release.
Dentsply Sirona
Operating Instructions
67 15 481 D3696
D3696.201.01.03.02 04.2019