Switching The Units Off - Dentsply Sirona CEREC Primescan AC Notice D'utilisation

4 Installation and startup
4.4 Initial startup
42
3. Switch the milling unit on (see the Operating Instructions for the
milling unit).
4. After loading the operating system, start the CEREC SW / Connect
SW application by double-clicking on the CEREC SW / Connect SW
icon.
NOTE
In order to prevent data security breaches, it is recommended that
users enable the password-protected login function for the Windows
operating system.
4.4.5

Switching the units off

NOTE
Proper shutdown procedure
The operating system must always be shut down properly to prevent
data loss.
To prevent the PC from progressively getting slower over time, shut
the operating system down properly at regular intervals.
1. Exit all programs.
2. Power down the operating system.
Ä The PC automatically switches off.
3. Switch the acquisition unit off at the main switch.
Ä The operating state LED goes out.
NOTE: Now you can also switch the milling unit off if necessary.
Dentsply Sirona
Operating Instructions
67 15 481 D3696
D3696.201.01.03.02 04.2019