Initial Startup; Plug Connections - Dentsply Sirona CEREC Primescan AC Notice D'utilisation

Dentsply Sirona
Operating Instructions
67 15 481 D3696
D3696.201.01.03.02 04.2019

Initial startup

4.4
For details on commissioning, see also the "Unpacking and Installation
Instructions" document provided with the unit.
4.4.1

Plug connections

NOTE
The CEREC Primescan / Primescan / CEREC Omnicam / Omnicam
scanner is a high-precision optoelectronic scanning instrument for
non-contact impression taking which requires careful handling.
Incorrect handling (impacts, dropping) leads to failure of the scanner.
➢ Always place the sensitive scanner in its holder!
NOTE
Risk of damage posed by pulling on the scanner cable
If the CEREC Primescan AC / Primescan AC / CEREC Omnicam
AC / Omnicam AC is moved by pulling on the scanner cable, there is
a risk of damage to the cable, scanner and device.
➢ Never pull on the scanner cable to move the CEREC Primescan
AC / Primescan AC / CEREC Omnicam AC / Omnicam AC.
➢ Always grab the CEREC Primescan AC / Primescan AC / CEREC
Omnicam AC / Omnicam AC by the handle to move it.
1. Make sure that the acquisition unit is switched off (main switch is at
0).
2. Insert the window sleeve onto the CEREC Primescan / Primescan
scanner. Exercise a great deal of care. Push the window sleeve
carefully onto the cone until it latches in.
3. Connect the unit to the line voltage with the power cord.
4. Carefully insert the connector of the scanner cable into the coupling
on the CEREC Primescan AC / Primescan AC / CEREC Omnicam
AC / Omnicam AC, watching out for the guide nose.
NOTE
Do not damage cable
If you pull on the cable itself in order to unplug it or to check the plug
connection, you will damage the cable.
➢ Never pull on the cable.
➢ Slide the moving part of the plug-in coupling upward on the
CEREC Primescan AC / Primescan AC / CEREC Omnicam AC /
Omnicam AC. At the same time, hold the scanner connector in
place.
5. Check the plug connections of the power supply and the scanner.
The scanner always remains connected.
4 Installation and startup
4.4 Initial startup
37