Setting The Thresholds; Programming The; Initial Angle Of Inclination (Optional) - Becker Centronic SensorControl SC211 Notice De Montage Et D'utilisation

Assembly and Operating Instructions
Attention
A threshold must be set which does not exceed the maximum permitted
load for the folding-arm awning.
1) Extend the folding-arm awning to the limit position.
2) Position the threshold regulator on the SWC241 in the middle.
3) Grasp the front section of the folding-arm awning and shake it in a way that
represents the force at which you want the folding-arm awning to retract, for
at least 5 seconds.
4) If the folding arm awning remains extended, the wind threshold must be set
to a more sensitive setting; then repeat the test.
5) If the folding-arm awning retracts fully, the threshold is at the correct
setting.
Note
The folding-arm awning must not be extended for 15 seconds after re-
traction.

initial angle of inclination (optional)

Note
The folding-arm
programming the initial angle of inclination.
1) Extend the folding-arm awning to the limit position.
2) Turn off the power to the system.
3) Open the SC211.
4) Press the programming button for at least 6 seconds until the LED goes from
green to red briefly and then back to green.
5) Close the SC211.
6) Now turn the power to the system back on.
This completes the programming process.
24

4. Setting the thresholds

5. Programming the

awning must be completely still when