Restoring The Factory Settings Of The Sensor; Assembly - Becker CentronicPLUS Notice De Montage Et D'utilisation

Restoring the factory settings of the sensor

10s
In order to ensure the correct functioning of the sensor,
the sensor surfaces must not be covered.
26 - en
Press the programming button and the function/control button for
10 seconds.
▻ The indicator lamp flashes red. Once the data has been
deleted, the indicator lamp will flash green twice, and the
device will reboot.
► When the indicator lamp has gone out, the radio receiver has
been reset to the factory settings.

Assembly

• Check that the transmitter and re-
ceiver are functioning perfectly prior
to installation in the desired location.
• Fix the sensor to the wall using the
three enclosed screws.