Setting The Release Angle (Optional) - Becker Centronic SensorControl SC211 Notice De Montage Et D'utilisation

Caution
It is important to follow steps 1-5 in the correct order.

1. Setting the release angle (optional)

Caution
The release angle may only be set by a specialist in accordance with the
specific features of the folding-arm awning.
1) Open the SC211 and remove the PCB.
2) Set the release angle on the threshold control switch.
3) Slide the PCB back into the SC211 and close the cover.
4) This completes the setting process.
The factory default is 0 (off).
Note
The release angle setting is applied once the initial angle of inclination
is set (Section 5).
de
en
fr
nl
21