Programming The Remote Control - Becker Centronic SensorControl SC861 Notice D'utilisation

Programming the remote control

Note
Before the SC861 is programmed, a master transmitter (e.g. SWC441)
must be programmed in the receiver (e.g. tubular drive R30/17PSF(+))
and the fi nal positions pre-programmed.
Caution
Before programming the master transmitter, always ensure that there
are no obstructions in the immediate operating area of the sun protec-
tion system, as the system may extend unexpectedly.
Programming the SC861
The SC861 features an integrated radio transmitter.
a) Press the programming pushbutton of the master transmitter until acknowl-
edgement is given by the receiver.
b) Press the programming pushbutton on the SC861 until the receiver confi rms
the signal setting.
c) Now press the programming pushbutton on the new SC861 to be pro-
grammed once more.
The receiver will indicate when the learn process has been successfully com-
pleted.
The maximum radio range is up to 25 m indoors and up to 350 m in the open.
DE
GB
FR
NL
13