Changing Batteries; Technical Data - Becker Centronic SensorControl SC211 Notice De Montage Et D'utilisation

Assembly and Operating Instructions
Caution
Extend the folding-arm awning to the best position for changing the
batteries and then turn off the power to the system. After you have
changed the batteries, turn the power back on.
Rated voltage
Degree of protection
Battery type
Range of inclination
Permissible ambient temperature
Radio frequency
Type of mounting
26

Changing batteries

1. Undo the housing screw and care-
2. Carefully remove the PCB from the
3. Take out the batteries.
4. Insert the new batteries correctly.
5. Carefully slide the PCB back into the
4. Then slide the cover back over the

Technical data

fully pull back the cover as far as it
will go.
housing.
housing.
housing and screw the screw back
in.
3 V DC
IP44
LR 03 (AAA)
0° bis 90°
-25 to +55°C
868.3 MHz
On front section