Programming The Remote Control - Becker Centronic SensorControl SC561 Notice De Montage Et D'utilisation

Programming the remote control
Note
Before the SC561 can be programmed, a master transmitter (e.g.
SWC441) has to be programmed into the radio receiver for sun protec-
tion systems, and the limit stops have to be programmed.
It is possible to program up to 3 sensors into the radio receiver for sun
protection installations.
The SC561 is supported by Becker tubular drives types PSF(+) and
PSEF from series no. 0723... onwards.
Caution
Before programming the master transmitter, always ensure that there
are no obstructions in the immediate operating area of the sun protec-
tion system, as the system may extend unexpectedly.
Programming the SC561
The SC561 features an integrated radio transmitter.
a) Press the programming pushbutton of the master transmitter until acknowl-
edgement is given by the receiver.
b) Press the programming pushbutton on the SC561 until the receiver confirms
the signal setting.
c) Now press the programming pushbutton on the new SC561 to be pro-
grammed once more.
The receiver will indicate when the learn process has been successfully com-
pleted.
The maximum radio range is up to 25 m outside and inside the building and up
to 350 m in the open.
de
en
fr
nl
13