Becker Centronic SensorControl SC211 Notice De Montage Et D'utilisation page 25

Switching off the angle of inclination
1) Extend the folding-arm awning to the point where you can reach the SC211.
2) Turn off the power to the system.
3) Open the SC211 and carefully remove the PCB.
4) Turn the rotary switch to position 0.
5) Slide the PCB back into the SC211.
6) Then press the red button for 6 seconds until the LED lights up green briefly.
6) Close the SC211.
7) Now turn the power to the system back on.
This completes the process.
Changing the angle of inclination
1) Extend the folding-arm awning to the limit position.
2) Turn off the power to the system.
3) Set the new release angle (see Section "1. Setting the release angle").
4) Now programme the initial angle of inclination
(see Section "5. Programming the initial angle of inclination").
This completes the process.
de
en
fr
nl
25