What To Do If; General Declaration Of Conformity - Becker Centronic SensorControl SC211 Notice De Montage Et D'utilisation

Problem
Awning extends in jerky
movements.
Awning does not move.
Awning does not extend
to the limit position and
then retracts despite
calm conditions.
Awning does not react
to wind.
An increase or decrease
in the awning's angle
of inclination is not
detected.

General Declaration of Conformity

Becker-Antriebe
SensorControl SC211 complies with the fundamental requirements and other
relevant guidelines of Directive R&TTE 1999/5/EC.
Intended for use in the following countries: EU, CH
Subject to technical changes without notice.

What to do if...?

Cause
The SC211 batteries are
almost dead.
1. Batteries in SC211
are dead.
2. Batteries are
inserted incorrectly.
Vibration is detected
when the awning is
extending.
1. The SC211 is not
programmed.
2. The wind threshold
is not at the correct
setting.
1. The rotary switch for
the release angle is
set to "0".
2. The initial angle of
inclination has not
been programmed.
GmbH declares
Remedy
Insert new batteries.
1. Insert new batteries.
2. Insert batteries
correctly.
Adjust the wind
threshold on the master
transmitter.
1. Programme the
SC211.
2. Adjust the wind
threshold on the
master transmitter.
1+2. Set the release
angle and pro-
gramme the initial
angle of inclination.
that the device
de
en
fr
nl
Centronic
27