Dolmar MS-4300.4 R Instructions D'emploi D'origine page 26

CLEANING OF FUEL FILTER
WARNING: INFLAMMABLES STRICTLY PROHIBITED
Interval of Cleaning and Inspection: Monthly (every 50 operating hours)
Suction head in the fuel tank
Check the fuel filter (1) periodically. To check the fuel filter, follow the steps below:
1. Remove the fuel tank cap, drain the fuel to empty the tank. Check the tank
inside for any foreign materials. If any, remove them.
2. Pull out the suction head by using a wire hook through the tank opening.
3. If the fuel filter clogged slightly, clean it. To clean it, gently shake and tap it in
fuel. To avoid damage, do not squeeze or rub it. The fuel used for the cleaning
must be disposed in accordance with the method specified by regulations in
your country.
If the fuel filter became hard or heavily clogged up, replace it.
4. After checking, cleaning or replacing, insert the fuel filter into the fuel pipe (3)
and fix it by the hose clamp (2). Push the fuel filter in all the way to the bottom
of the fuel tank.
Clogged or damaged fuel filter can cause insufficient fuel supply and reduce en-
gine power. Replace the fuel filter at least quarterly to ensure satisfactory fuel
supply to the carburetor.
REPLACEMENT OF FUEL PIPE
CAUTION: INFLAMMABLES STRICTLY PROHIBITED
Interval of Cleaning and Inspection: Daily (every 10 operating hours)
Replacement: Annually (every 200 operating hours)
Replace the fuel pipe (1) every year, regardless of operating frequency. Fuel
leakage may lead to fire.
If any leakage is detected during inspection, replace the fuel pipe immediately.
INSPECTION OF BOLTS, NUTS AND SCREWS
Retighten loose bolts, nuts, etc.
●
Check the fuel cap and oil cap for tightness. Check for fuel and oil leakage.
●
Replace damaged parts with new ones for safety operation.
●
CLEANING OF PARTS
Always keep the engine clean by wiping down with a cloth rag.
●
Keep the cylinder fins free of dust or dirt. Dust or dirt adhering to the fins will
●
cause piston seizure.
REPLACEMENT OF GASKETS AND PACKINGS
Replace gaskets and packings if the engine is disassembled.
Any maintenance or adjustment work that is not included and described in this manual is only to be performed by Authorized Service Agents.
26
(3)
(2)
(1)
(1)
(1)