Dolmar MS-4300.4 R Instructions D'emploi D'origine page 25

CHECKING THE SPARK PLUG
Only use the supplied universal wrench to remove or to install the spark plug.
●
The gap between the two electrodes of the spark plug should be 0.7 – 0.8 mm
●
(0.028" – 0.032"). If the gap is too wide or too narrow, adjust it. If the spark plug
is clogged or contaminated, clean it thoroughly or replace it.
Place the plug cap properly as illustrated after checking.
CAUTION:
Never touch the spark plug connector while the engine is running (danger
●
of high voltage electric shock).
SUPPLY OF GREASE TO GEAR CASE
Supply grease (Shell Alvania 2 or equivalent) to the gear case (1) through the
●
grease hole (2) every 25 hours. (Genuine DOLMAR grease may be purchased
from your DOLMAR dealer.)
SUPPLY OF GREASE TO THE FLEXIBLE SHAFT
1. Remove the flexible shaft from the clutch case and the straight shaft. To
remove the flexible shaft from the clutch case, pull up the knob and remove
it. To remove the flexible shaft from the straight shaft, remove the bolt and
remove it.
2. Pull out the inner shaft (1) from the flexible liner (2), and apply grease (Shell
Alvania 2 or equivalent) (3) on the inner shaft for every 25 hours. (Genuine
DOLMAR grease may be purchased from your DOLMAR dealer.)
NOTICE:
The flexible shaft may be broken if no grease is applied.
●
For extending service life of the parts, reinstall each end of the flexible
●
shaft onto the opposite side, i.e. formerly engine side onto the control lever
side.
0.7 mm – 0.8 mm
(0.028" – 0.032")
(2)
25
(1)
(2)
(1)
(3)