Dolmar MS-4300.4 R Instructions D'emploi D'origine page 22

4. Wind all but about 100 mm (4") of the cords, leaving the ends temporarily
hooked through notches (6).
5. Mount the spool in the cover as holding notches meet the eyelets (7).
Unhook the ends of the cord from their temporary position and feed the cords
through the eyelets.
6. Align the square slits (8) on the housing with the eyelets (7). Then push the
housing firmly onto the cover to secure it. Make sure the latches (1) fully
spread in the cover.
(1)
22
(6)
(7)
(8)
(7)
(1)