Final Tests; Periodic Maintenance; Maintenance - SORHEA COLIRIS II Notice D'installation

SORHEA
9

FINAL TESTS

After installation, verify correct operation with a complete test.
• Interrupt two adjacent cells and verify activation of the intrusion alarm.
• If mono-detection is validated, interrupt the cell and verify activation of the intrusion alarm.

10 PERIODIC MAINTENANCE

To ensure proper performance over time, minimum maintenance should be performed:
- Clean the cap of each component at least once a year, (or more often depending on
exposure to foreign elements and grime).
- Repeat the final tests (once per year).

11 MAINTENANCE

The type of column is identified by an audio signal when the power is turned on:
a COLIRIS II 50 column 1 beep.
-
a COLIRIS II 100 column 2 beeps.
-
a COLIRIS II 200 column 3 beeps.
-
Malfunction
All indicator lights are off
Red indicator light « Alarm »
and Orange indicator light
« Disq. » are lit up
Orange indicator light « Disq. »
lit and green indicator light
« Sync. » off
Orange indicator light « Disq. »
lit and green indicator light
« Sync. » lit
The cells are disconnected but
the red indicator light « Alarm »
is not lit up
The output relays are not
transmitting.
Probable cause
- Improper power supply
Power supply voltage 12V
< 9V DC
nd
- The 2 column forming the
detection zone has no power
- Different channel on the
columns forming the detection
zone
- Poor alignment
- Some cells are blocked
- The 2 cells are not interrupted
at the same time
- The switch mode « low
consumption » is in the position
Output OFF
- 39 -
COLIRIS II 50/100/200
Solution
- Check power supply
- Verify power supply wiring
- Check battery
- Check power supply
- Change the channel for
one of the columns
- Readjust the alignment
- Disengage the cells
- Interrupt the cells
simultaneously
- Set the switch mode « low
consumption » to the
Output ON position