SORHEA COLIRIS II Notice D'installation page 35

SORHEA
5. Hold down the push-button « Select » (for at least 2 seconds) until the buzzer beeps 3 times.
The number of the cell being aligned is indicated by the number of flashes of the three indicator
lights and the number of beeps of the buzzer.
Note : cell 1 is located at the bottom of the column
6. Maneuver the cell until the buzzer signal becomes continuous or at least 2 indicator lights light up.
COLIRIS II 200 (with 4 connected cells) :
COLIRIS II 200 with 3 connected cells is equivalent to 2 beams.
The state of alignment of a COLIRIS II 200 beam depends on the signal received by the two cells that
composed it.
Example: In COLIRIS II 200 4 cells. The signal received by beam 1 depends on cells 1 and 2.
Note : COLIRIS II 50/100 aligns itself cell by cell
COLIRIS II 200 aligns itself beam by beam
Visualizing the status of alignment :
Note : In the absence of a signal, the buzzer beeps 1 time per second.
7. Move to the following cell by pressing the push-button. The three flashing indicator lights and the
beeping buzzer indicate the number of the cell to be aligned or the beam in the case of COLIRIS
II 200.
Beam 1 is comprised of cells 1 and 2
Beam 2 is comprised of cells 2 and 3
Beam 3 is comprised of cells 3 and 4
Alignment
status
Poor
Good
Excellent
→
X Light on
- 34 -
Cell 4
Cell 3
Cell 2
Cell 1
Indicator lights on
Red Green Orange
X
X X
X X
COLIRIS II 50/100/200
X