Channel Selection; Barrier Alignment - SORHEA COLIRIS II Notice D'installation

SORHEA

7.2 Channel selection

To prevent interference by one barrier with another on the same site, barriers are equipped with four
selectable frequencies (channels).
The 2 columns that comprise a barrier must be configured with the same channel number. This
configuration is performed by using the switches on the control console.
Note: The channel is validated when the power is turned on. (Action on the switch has no effect on
the selection of the channel once the column is powered).
Channel 1

7.3 Barrier alignment

Green indicator light « Sync. » :
Synchronization of the
column
Red indicator light « Alarm » :
intrusion alarm
Push-button « Select » :
- Column alignment
- cell selection in alignment
mode
Channel 3
Channel 2
Assignment of channels according to column availability.
1 2
CHANNEL 1 CHANNEL 2
Channel 4
- 33 -
COLIRIS II 50/100/200
1 2 1 2
CHANNEL 3
Channel 3
Channel 4
Channel 2
Channel 1
Orange indicator light « Disq. » :
disqualification alarm
Adjusting response time of
the intrusion alarm (from 45 to
800 ms)
1 2
CHANNEL 4