Adjusting Response Time Of The Intrusion Alarm; Setting Options; Wiring In Series (Serial Links) - SORHEA COLIRIS II Notice D'installation

SORHEA
Note : If a cell is manually excluded, alignment will automatically move to the number of the
following cell.
8. To exit from alignment mode, hold down the push-button « Select » for over 2 seconds until the
buzzer beeps 3 times.
Note: Verify that the green synchronization Indicator lights is lit up. If it is not, recommence
alignment of the entire column.

7.4 Adjusting response time of the intrusion alarm

Adjust the response time using the trim-pot. (See section 7.3)
Note : Validation and response time for mono-detection is performed solely via the settings
options (see section 8).
Response
50 ms
time

8 SETTING OPTIONS

8.1 Wiring in series (serial links)

The control unit is equipped with an HE14 2x5 pts connector to be able to configure the card via
RS232 serial cable using the Hyper Terminal application (software application supplied by Windows*).
* Windows is a registered trademark of Microsoft Corporation.
200 ms 400 ms
HE14 2x5 pts
Connector
Control unit connector
- 35 -
COLIRIS II 50/100/200
550 ms
9 7 5 3 1
10 8 6 4 2
800 ms