Installation - SORHEA COLIRIS II Notice D'installation

SORHEA

5 INSTALLATION

Regardless of the means of attachment used, it is necessary to mount the spacers behind the frame
in order to free up enough space for removal of the top cover (cap).
1
2
Wall fastening
4 wood screws 4.8 X 60
Removing the cap:
Remove the mounting screw(s) for the cap and remove the
cap by letting it slide about 5 cm towards the bottom (1).
Then move it towards the exterior (2) to extract it (taking care
not to change the direction of the cells).
Replacing the cap:
• Mount the cap on the guide bolts on top of the column so
that the cap opens up and fits onto the rails of the frame
(taking care not to change the direction of the cells).
• Slide the cap upwards, while keeping it at the level of the
guide bolt. Slide the cap progressively down the frame.
• Make sure that the cap clips firmly into the top flanges and
attach the cap with the anchoring screw(s).
70
(*)
Spacers
• Remove the plugs filling the mounting holes.
• Install the spacers at the rear of the frame by
aligning them with the mounting holes. The
spacers remaining must be mounted in pairs
equidistant from the first ones.
• Attach the column to the wall.
• Pass the cabling through the bottom of the
column.
(*) : see 12 « technical features »
- 28 -
COLIRIS II 50/100/200