SORHEA COLIRIS II Notice D'installation page 38

SORHEA
8. Select the communication port to which the control unit is connected
9. Enter the settings for the port as indicated here below
10. Hyper Terminal is ready to transmit data.
All commands must be typed in upper case.
If there is an error in the choice of a command, type « Q ». The command in progress is then
ignored and Hyper Terminal then waits for a new command.
If a command is not terminated after 1 min 30, the command in progress is then ignored and
Hyper Terminal then waits for a new command.
4 possible commands :
- Activation of mono-detection
- Response time for mono-detection
- Heater instruction
- Read control unit settings
Note : Only valid commands are displayed.
Mono-detection is not valid except for the cell linked to connector 1.
- 37 -
COLIRIS II 50/100/200