Shipping, Storage And Handling; Machine Shipping Conditions; Machine Storage And Shipping Specifications; Unpacking/Assembly - Corghi PW IW 6 Manuel D'utilisation

SHIPPING, STORAGE AND HANDLING

The cone-to-cone machine must be shipped in its original packaging and kept in the
position indicated on the packing.
- Packaging dimensions (fig. 1):
• width ........................................................................................................................ mm 1720
• depth ....................................................................................................................... mm 1050
• height ...................................................................................................................... mm 1450
- Weight of the machine with packaging:
•PW IW three-phase ..................................................................................................... 301 Kg
Machine storage and shipping specifications
Temperature: -25°C to +55°C.
WARNING
To avoid damage do not place other articles on top of the packages.
To move the packing, insert lift forks into the slots in the base of the packing unit (pal-
let) (Fig. 1).
Refer to the section on LIFTING AND HANDLING for instructions on how to move the
machine.
WARNING
Keep the original packing; it could be useful in the future for machine transfer.

UNPACKING/ASSEMBLY

WARNING
The unpacking, assembly, lifting and installation procedures which follow should be
performed according to instructions.
Failure to comply with these instructions could damage the machine and put the
operator at risk.
Remove the upper part of packing from the machine. Check the machine was not dam-
aged during shipping and identify pallet attachment points (Fig. 1).
At this point the machine is ready for installation.
N.B. If the machine is equipped with add-on sections, refer to the section on Installing
Additional Sections.
PW IW 6" 8" 10" operator's manual

Machine shipping conditions

Handling
GB
25