Lifting/Handling; Place Of Installation; Work Environment Conditions; Installation - Corghi PW IW 6 Manuel D'utilisation

Masquer les pouces Voir aussi pour PW IW 6:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

To remove the machine from the pallet, lift it as shown in Fig. 2.
The same lifting point must be used every time the site of machine installation is changed.
Remember to disconnect the machine from its pneumatic and electric power supply
before beginning such an operation.

PLACE OF INSTALLATION

WARNING
The place where the machine is to be installed must conform to applicable safety at
work regulations.
WARNING
The machine must not be installed in an open area.
Move the machine to the designated installation site, respecting the minimum distances
reported in Fig. 3.
- Relative humidity: 30% - 95% without condensation
- Temperature 0°C - +55°C
WARNING
The machine must not be operated in potentially explosive atmospheres.
ATTENTION
Place at a distance of at least 60 cm from any heat source (fig. 3).
Level the machine using the adjustable feet (7 fig.4).
Hook-up to the electric mains (see the section on Electrical and Pneumatic hook-up).
Various configurations can be created by adding sections to the base section.
To make a multi-section configuration add one additional section to the base section and
so on, up to a permitted maximum of 48 heads.
26

LIFTING/HANDLING

Work environment conditions

INSTALLATION

PW IW ~ 6" 8" 10" base section
PW IW ~ 6" 8" 10" additional section
PW IW 6" 8" 10" operator's manual

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Pw iw 8Pw iw 10Icl iw

Table des Matières