Installation; Rigging Material; Connecting Speakers - L-Acoustics 115XT HiQ Manuel Utilisateur

6

INSTALLATION

6.1

Rigging material

The integrated rigging components and the wedge-shaped cabinet design of the 115XT HiQ enclosure (Figure 2) allow
for various setups such as:
• Wall or ceiling-mounting using L-ACOUSTICS
•
Flying using the L-ACOUSTICS
•
Mounting to a 35mm/1.38in pole stand using the integrated pole socket.
•
Stacking with two fixed angle settings of 30° and 60° with regard to the vertical.
!
Refer to the "XT and P'' rigging manual to get acquainted with rigging procedures specific to the
XT range.
WARNING
6.2

Connecting speakers

The 115XT HiQ enclosure is driven and powered by the dedicated amplified controller L-ACOUSTICS
the LA4 amplification channels 1 and 3 can drive one or two 115XT HiQ enclosures in parallel. The channel assignment
varies upon the preset selected by the user for a given application. For more details please refer to the "LA4'' user
manual, also available on the L-ACOUSTICS internet website @ www.l-acoustics.com.
The 115XT HiQ enclosure is equipped with two NL4FC Speakon
to an LA4 output channel, and the second is for connecting an additional 115XT HiQ enclosure.
To connect the 115XT HiQ enclosure to the amplified controller LA4 (Figure 3), L-ACOUSTICS recommends using L-
ACOUSTICS cables SP10 or SP25 with length of 10 m (32.8ft) and 25 m (82ft), respectively. Cable SP.7 should be
used for connection between two adjacent 115XT HiQ enclosures.
The L-ACOUSTICS wiring convention is as follows:
Speakon ®
HiQ_UM_ML_1
®
® XTLIFTBAR rigging accessory.
connector labels
1+
1-
2+
2-
w w w . l - a c o u s t i c s . c o m
ETR15 mounting accessory.
® connectors wired in parallel: one is for connecting
Connections to transducers
® LA4. Each of
LF +
LF -
HF +
HF -
9 en
EN