Disassembling - L-Acoustics 115XT HiQ Manuel Utilisateur

3. a. Insert the enclosure's bottom pole socket into the U-bracket's stud.
b. Rotate the pivoting arm into position.
c. Select the desired enclosure's orientation and firmly screw the knob.
d. Secure the locking pin on the pivoting arm.
!
Verify that the enclosure is correctly secured by checking that it cannot rotate freely.
Verify that the pivoting arm is secured by checking that the locking pin is correctly engaged and
cannot move freely.
When installing the enclosure in the vertical orientation, always position the ETR8-2 U-bracket
with the fixed arm underneath the enclosure.
WARNING
!
L-ACOUSTICS recommends using an additional safety point when rigging enclosures.
A safety eye-bolt accessory can be added using the 8mm/0.31in insert located on the rear face
of the 8XT enclosure (see Figure 18).
WARNING
6.1.2

Disassembling

Disassembling should be carried out in the reverse order of assembly.
XTP_RM_ML_1
b.
a.
Figure 9: Securing the ETR8-2 to the enclosure
w w w . l - a c o u s t i c s . c o m
c.
d.
EN
13 en