L-Acoustics 115XT HiQ Manuel Utilisateur page 40

XT
COAXIAL RANGE -
Rigging Procedures
VERSION 1
!
7. Suspension points
It is the user's responsibility to ensure that the Working Load Limit (WLL) of the suspension
points and/or chain hoists is greater than the total weight of the loudspeaker assembly in use.
WARNING
!
8. System load capacity and setup safety limits
Load capacity and setup safety limits when flying or stacking a loudspeaker assembly should be
strictly followed according to the instructions outlined in this manual.
Always refer to the mechanical data and warning indications provided in SOUNDVISION to
verify that safe system setup safety limits apply.
WARNING
!
9. Local regulations
Some countries require higher Ultimate Strength Safety Factors and specific rigging approvals: it
is the user responsibility to ensure that any overhead suspension of L-ACOUSTICS systems has
been made in accordance with all applicable local regulations.
As a general rule, L-ACOUSTICS recommends the use of safety steel at all times.
WARNING
!
10. Flying a loudspeaker assembly
Always ensure that nobody is standing underneath the loudspeaker assembly when it is being
raised. As the system is being raised check each individual component to make sure that it is
securely fastened to the component above. Never leave the system unattended during the
installation process.
WARNING
!
11. Ground stacking a loudspeaker
Do not ground stack the system on uneven ground or platform. If the system is ground stacked
on a structure, platform, or stage always check that it can support the total weight of the system.
When necessary secure the system to a stable platform or structure.
WARNING
!
12. Dynamic load
When a loudspeaker assembly is deployed in an open air environment wind effect should be
taken into account. Wind can produce additional dynamic stress to the rigging components and
suspension points. If the wind force exceeds 6bft (Beaufort scale) it is highly recommended to
lower down and/or secure the loudspeaker assembly.
WARNING
13. Manual
!
Keep this manual in a safe place during the lifetime of the product.
This manual forms an integral part of the product.
Reselling of the product is only possible if the user manual is available.
Any changes made to the product have to be documented in writing and passed
IMPORTANT
on to the buyer in the event of resale.
XTP_RM_ML_1
P
SELF-POWERED COAXIAL RANGE
w w w . l - a c o u s t i c s . c o m 2 en