Rigging The 12Xt Or 112P (Resp.115Xt Hiq) Enclosure With The Etr12 (Resp. Etr15); Assembling - L-Acoustics 115XT HiQ Manuel Utilisateur

XT
COAXIAL RANGE -
Rigging Procedures
VERSION 1
6.2

Rigging the 12XT or 112P (resp.115XT HiQ) enclosure with the ETR12 (resp. ETR15)

6.2.1

Assembling

The ETR12 (resp. ETR15) U-bracket is secured to the 12XT or 112P (resp. 115XT HiQ) enclosure in the following way:
1. a. Remove the locking pin located on the U-bracket's pivoting arm.
b. Pull on the spring-loaded pin and open the pivoting arm.
a.
2. a. Insert one enclosure's pole socket into the stud located on the U-bracket's fixed arm.
b. Rotate the pivoting arm into position: the spring-loaded pin will re-engage automatically into its initial position.
b.
!
Verify that the pivoting arm is secured by checking that the spring-loaded pin is engaged and
that the pivoting arm cannot move freely.
When installing the enclosure in the vertical orientation, always position the U-bracket with the
fixed arm underneath the enclosure.
WARNING
XTP_RM_ML_1
P
SELF-POWERED COAXIAL RANGE
b.
Figure 10: Opening the pivoting arm
Figure 11: Securing the ETR12 to the enclosure
w w w . l - a c o u s t i c s . c o m
b.
a.
14 en