Disassembling - L-Acoustics 115XT HiQ Manuel Utilisateur

3. Select the desired enclosure's orientation (10° steps angle selection) and secure the locking pin to the enclosure
through the U-bracket's pivoting arm.
Figure 12: Selecting and securing the enclosure's orientation
!
The locking pin must be located on the pivoting arm (and not on the fixed arm) to secure the
U-bracket to the enclosure.
Verify that the enclosure is secured to the U-bracket by checking that the locking pin is engaged
and cannot move freely.
WARNING
!
L-ACOUSTICS recommends using an additional safety point when rigging enclosures.
A safety eye-bolt accessory can be added using the 8mm/0.31in insert located on the rear face
of the 12XT enclosure (see Figure 18).
WARNING
6.2.2

Disassembling

Disassembling should be carried out in the reverse order of assembly.
XTP_RM_ML_1
Select the
enclosure
angle in 10°
steps
w w w . l - a c o u s t i c s . c o m
EN
15 en