XT
COAXIAL RANGE -
Rigging Procedures
VERSION 1
6.3
Rigging the SB15P enclosure with the ETR15P
6.3.1
Assembling
The ETR15P is secured to the SB15P enclosure in the following way:
1.
Remove the recessed set screw located on the bottom face of the enclosure.
Note: Put the screw in a safe place.
2.
Pull on the U-bracket's locking pin and open the pivoting arm.
XTP_RM_ML_1
P
SELF-POWERED COAXIAL RANGE
Recessed set
screw
Figure 13: Recessed set screw
Figure 14: Opening the pivoting arm
w w w . l - a c o u s t i c s . c o m
16 en