Vermeiren Eris Manuel D'utilisation page 22

 If your scooter is stored for a while, it is advised to charge the ba ttery regularly
(approximately once a month).
 Do not interrupt the c harging cycle; wait till the charger indicates that the battery is
fully charged, see the charger instruction manual. Prevent charging for a short
period. Note: this is NOT applicable for Lithium batteries.
 The battery may be irreversibly damaged if the b attery is fully discharged.
Therefore, make sure that the battery is charged on time.
 The lifespan reduces if the battery is exposed to extreme cold for a longer period of
time, see the technical details in §1.3.
 Make sure that all connection points on the battery and the connection point in the
battery housing are free of dust and other contamination.
 Protect your battery from large sources of electromagnetic radiation.
Fully recharge your new battery before its first time use.
The light emitting diode (LEDs) in the steering unit indicates the remaining capacity of your batteries. If
the battery charger is turned on and no LED's are lit, check the fuse. If the red LED does not illuminate
the charger is defective, consult your specialist dealer.
1. Switch the scooter OFF and remove the key.
2. FIRST connect the battery charger to a
230V AC power socket.
3. If applicable, open the cover (2) of the
charging point on the scooter, see picture.
4. Connect the charger.
5. Refer to the battery-charger manual for the
explication of the indicators on the charger.
6. When the battery is fully loaded, disconnect
the battery.
7. Switch the scooter ON and check if all lights
of the battery status indicator are ON.
8. Remove the charger from the socket, let it
cool down and store it on a dry location.
In case of any problems whereby the battery cannot be ch arged according to the instructions in
the charger manual, please contact your specialist dealer.
When the operating console displays the error code "Drive inhibit" after charging, make sure
that the battery charger is disconnected. This safety measure prevents driving with the charger
still connected to the supply grid.
1 = Key lock
2 = Socket battery charger
Page 18
Eris
2019-03