Thermal Fuses - Vermeiren Eris Manuel D'utilisation

Check all around on both sides that the tube is not pinched between the rim and the edge of the tyre.
Lightly push the air valve inwards and pull it out again to make sure that the tyre is positioned properly
in the region of the air valve.
To ensure that the wheel is inflated correctly, admit only so much air initially that the tyre can still be
easily pushed inwards by using your thumbs. If the check-lines are equidistant from the edge of the
rim on both sides of the tyre, then the tyre is centered properly. If not - let out the air and position the
tyre afresh. Now the tyre can be inflated to its full operating pressure (note the maximum) and the
valve cap should be replaced.
Only an expert can guarantee correct assembly. Work not done by your specialist dealer, would void
any warranty claims.
When inflating the tyres, always check that the pressure is correct. The correct pressure is given on
the tyre walls.
Use only inflating equipment which complies with regulations and indicates the pressure in bar. We do
not accept any liability for damage caused by using inflation equipment not supplied by the
manufacturer.
3.9

Thermal fuses

The thermal safety device can go loose if you go up or down slopes that exceed the maximum
gradient indicated. Nominal loads that exceed the maximum permitted could also cause the device to
jump out. Likewise, if you keep on driving with the engine brake on, it could result in overload. The
maximum values not to exceed are indicated in the chapter "Technical Specifications" of the
corresponding manual.
To be able to use the scooter again, remove the overload and wait till the motor has cooled off. Then
gently switch the thermal safety mechanism back in. Your scooter is now ready for use again.
DISMANTLING
1. Unscrew and remove the middle screw
attach the wheel and flange to the scooter.
2. Let the air out of the wheel by lightly pressing
the pressure pin on the valve
3. Unscrew the 4 screws
rim. Separate the rim sides.
ASSEMBLY
Insert the partly-filled inner tube into the tyre.
1. Connect the two sides of the rim through the
tyres and place the flange against the tyre and
screw them back again with the 4 screws

2. Put the valve through the hole for it in the
rim.
3. Put the wheel and flange back on the scooter
and secure this connection with the middle
.
screw Inflate
recommended tyre pressure.
To protect the motor against overload, your scooter
have a thermal safety mechanism
your scooter. The thermal fuse will automatically cut
the motor to prevent overheating and thus rapid
wear and tear or breakdowns. You can access the
thermal safety device through a gap in the back of
the synthetic cover.
Page 23
Eris
2019-03

that

.

on the inside of the
.
the wheel to the

on the rear of