Elite arion DIGITAL Notice D'utilisation page 27

until the end of the program, the set degree of
graph.
allowing the rider to adapt the training according to his
To stop the training session press (long press, 3
To access the settings screen, select the SETTING
function from the menu using the side buttons, then
confirm the selection with the middle button. SETUP
button for 3 seconds.
The modifiable settings are:
- unit of measure: press the right button to select the
- weight: press the right button to increase the weight
and the left button to decrease it. Confirm the selection
- Age: press the left button to decrease the value and
pressing the middle button.
travelled; useful, for example, for checking the amount
of road covered on the training roller in a season. The
button (increasing it) or left button (decreasing it). Press
the middle button to confirm the value entered and go
to the next figure. The value can be reset as required
through the SETUP procedure.
- Total time: shows the total time of training done;
useful, for example, for checking the number of hours
of training done on the roller in a season. The total time
the right button (increasing it) or left button (decreasing
it). Press the middle button to confirm the value
entered and go to the next figure. The value can be
reset as required through the SETUP procedure.
- Training zone (TZ): this is an indication of the heart-
rate zone in which the rider is working. For a more
detailed explanation of the calculation of thresholds,
- Parameter relevant to the resistance unit: parameter
After-Sales Service. The correct value is 0270.
- Pairing 1: this function enables coupling between the
and the resistance unit, press the left button. The
speed and cadence fields will now start flashing. Wait
a few seconds for the message "YES" to appear in
case of correct coupling or "Err" in case of failed
coupling. In case of failed coupling, repeat the
procedure. If coupling is still unsuccessful, follow the
section.
- Pairing 2: this function enables coupling between the
make sure the chest strap is transmitting, then press
the left button. The heart-rate field will now start
flashing. Wait a few seconds for the message "YES" to
appear in case of correct coupling or "Err" in case of
failed coupling. In case of failed coupling, repeat the
procedure. If coupling is still unsuccessful, follow the
section.
accessing the SETUP menu.
EN
23