Elite arion DIGITAL Notice D'utilisation page 21

A
N°3 Side members
B
N°1 Longitudinal member with resistance
C
N°4 Rectangular covers
D
N°2 Round covers
E
N°1 Drive belt
F
N°1 Front roller
G
N°1 Middle roller
H
N°1 Rear roller
Measure the distance between the centres of the
DIGITAL (Fig. 2). We will call this dimension "X".
The distance from the intermediate point between
the two rear rollers to the middle of the
front roller, which we will call "Y" (Fig. 3), must match
or be as near as possible to dimension "X" . The axle
of the ARION DIGITAL front roller must be positioned in
the hole of the ARION DIGITAL
measurement given on the graduated scale is closest
to dimension "X" (Fig. 4).
ARION DIGITAL it is
ARION
ARION DIGITAL
frame whose
I
J
K
N°1 Rubber for support
L
N°3 O-rings
M
N°4 Zip ties
N
N°1 Power adapter
Fold the ARION DIGITAL
slackens.
Loosen the drive belt E), making it come off the
respective front and rear guides.
Unfold the ARION DIGITAL
position.
Remove the rectangular covers C) from both front
longitudinal members (with aid of a screwdriver if
5 and Fig. 6).
Pull the roller out from its original position.
Position the roller in the appropriate seat in the
holes in the frame, so that X matches Y.
Refit the screws and the washers in the special
holes, but do not tighten them down.
Close the ARION DIGITAL, position the drive belt E)
on the guide of the front roller F) and middle roller G).
Unfold the ARION DIGITAL
again.
Check the position of the front roller F), putting
Once the front roller F) has been positioned, tighten
could twist the A) side Frames.
Close the sides with the rectangular covers C). The
ARION DIGITAL
EN
until the drive belt E)
back into the open
into open position
17