Switching On Vox Mode - switel WT270 Mode D'emploi

The volume of the incoming call signal depends on your
volume setting. 16 volume levels can be set using the
and buttons.
Note: While you are holding the talk button, you will
not be able to hear any incoming calls. As is usual
with radio units, only one of the two participants in
the call can speak at any one time.
Therefore, always wait until you hear the signal tone before
pressing the talk button again.
While you are pressing the TALK button, the
appear in the display. When you receive a call, the
symbol will appear in the display.

3.6 Switching on VOX mode

In VOX mode, the radio will automatically start to transmit as
soon as your voice or another noise is detected. It is not
necessary to press the talk button. Transmission will always
take place for 2 seconds, even when you speak for less than
2 seconds.
Three sensitivity levels from 1 to 3 can be set for VOX mode.
With setting 1, even softer noises will be transmitted
whereas, with setting 3, only loud signals will be sent. In
setting 0, VOX mode is switched off (standard setting).
- Operation -
symbol will
59