Changing The Call Code (Ctcss) - switel WT270 Mode D'emploi

In order to be able to speak between two radios,
both units must be set to the same channel.
1. Press the MODE button once. The CHAN indicator will
flash in the display.
2. Select the required channel using the
buttons.
3. Confirm the selection with the talk button on the left-
hand side.

3.4.1 Changing the call code (CTCSS)

Normally, all calls on the selected channel are sent to all
radios that are in receiving range. You may therefore also
hear calls that are not intended for you when other people
are using radios on the same channel in the vicinity. In order
to prevent this, it is possible to define a call code. Check
between yourselves which code has been selected.
1. Press the MODE button twice. The CODE indicator
and the current call code will flash in the display.
2. A new code between 01 and 38 can now be selected
using the
selected, all calls will be made on the selected
channel.
3. Confirm the selection with the talk button on the left-
hand side.
- Operation -
and buttons. If the code -- is
and
57