Switching On Vox Mode - switel WT370 Mode D'emploi

However, in spite of this, we recommend that you finish your message
with the word "End" so that the person you are calling knows exactly
when he can reply.
The volume of the incoming call signal depends on your volume setting.
16 volume levels can be set using the
Note: While you are holding the talk button, you will not be able
to hear any incoming calls. As is usual with radio units, only one
of the two participants in the call can speak at any one time.
Therefore, always wait until you hear the signal tone before pressing
the talk button again.
While you are pressing the TALK button, the
the display. When you receive a call, the
display.
3.6

Switching on VOX mode

In VOX mode, the radio will automatically start to transmit as soon as
your voice or another noise is detected. It is not necessary to press the
talk button. Transmission will always take place for 2 seconds, even
when you speak for less than 2 seconds.
Three sensitivity levels from 1 to 3 can be set for VOX mode. With
setting 1, even softer noises will be transmitted whereas, with setting 3,
only loud signals will be sent. In setting 0, VOX mode is switched off
(standard setting).
1. Press the MODE button five times. The VOX indicator will flash in
the display.
2. Select the required sensitivity using the
setting 0, VOX mode is switched off.
3. Confirm the selection with the TALK button on the left-hand side.
52
- Operation -
and buttons.
symbol will appear in
symbol will appear in the
and buttons. In