Using The Softkeys; Navigating Between Menus; Navigating Within A Menu - Mettler Toledo SevenGo Duo pro SG68 Mode D'emploi

2. ppm
3. mg/L

4.4 Using the softkeys

The SevenGo Duo pro™ multi-parameter meter has three softkeys. The functions assigned to them
change during operation depending on the application. The assignment is shown on the bottom line of
the screen.
In the measurement screen, the three softkeys are assigned as follows:
Menu
Access meter settings
The other softkey functions are:
Delete

4.5 Navigating between menus

The meter display consists of a measurement frame, softkeys, areas for status icons and underlying
menu areas.
To access the menu areas and to navigate between them, use various softkeys (see "Using the soft-
keys").
a) Press Menu.
The Setup menu appears and Sample ID is highlighted.
b) Press
c) Press
d) Press
e) Press MODE/EXIT to return to the measurement screen.

4.6 Navigating within a menu

This example is based on the Setup menu, but the procedure applies to the other menus as well.
a) Press Menu.
The Setup menu appears and Sample ID is highlighted.
b) Press
c) Press Select to move deeper in the menu for the chosen operation.
d) Continue navigating with
menu.
e) Press MODE/EXIT to go back to the previous menu.
— or —
f) Press READ to return to the measurement screen directly.
pH/ORP/Ion/DO meter SG68
Store
Save an endpointed mea sure-
ment
Move one position to the right
Move one position to the left
Scroll up in the menu
Scroll down in the menu
Increase value
Decrease value
Scroll to next data set in memory
Delete letters or numbers on
alphanu mer ic keypad
Delete selected data
to highlight the Setup tab.
to highlight the pH/Ion tab.
to highlight the DO tab.
as often as needed to navigate to a menu item.
, or Select until the final destination is reached within the
Operating the pH/ORP/Ion/DO meter SG68
Data
Access data menu
Edit Edit table or value
End End calibration
Yes Confirm
No
Reject
Review
Review selected data
Save Save data, setting or value
Select Select the highlighted function or
set ting
Start Begin the reference measurement
Trans
Transfer selected data
11