Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
4.4 U sing the softkeys
The meter has four softkeys. The functions assigned to them change during operation depending
on the application. The assignment is shown on the bottom line of the screen.
In the measurement screen, the softkeys are assigned as follows:
Data
Access data menu
The other softkey functions are:
Delete
4.5 S electing a measurement mode
Press the MODE softkey to switch between the different measurement modes.
The sequence of the alternating measurement modes is:
1. Conductivity
2. TDS
3. Salinity
4. Resistivity
5. Conducitivity ash
For the conductivity mode, the user can choose between the units "μS/cm & mS/cm" and "μS/m &
mS/m". This setting can be made in the conductivity menu (see "Menus and settings: Conductivi-
ty mea s ure m ent settings").
4.6 N avigating between menus
The meter display consists of a measurement frame, softkeys, areas for status icons and under l y-
ing menu areas.
To access the menu areas and to navigate between them, use various softkeys (see "Using the
soft k eys").
1
Press Menu.
The Setup menu appears and the Cond. tab is highlighted.
2
Press
16 Operating the meter
Menu
Access meter settings
Move one position to the right
Move one position to the left
Scroll up in the menu
Scroll down in the menu
Increase value
Decrease value
Scroll to next data set in mem-
o r y
Delete letters or numbers on
alphanu m er i c keypad
Delete selected data
to highlight the Setup tab, or
Mode
Change measurement mode
Edit
Edit table or value
End
End calibration
Yes
Confirm
No
Reject
Review
Review selected data
Save
Save data, setting or value
Select
Select the highlighted function
or set t ing
Start
Begin the reference mea s ure-
ment
Trans
Transfer selected data
Publicité
Chapitres
Table des Matières
