Key Controls; Using The Softkeys; Selecting A Measurement Mode - Mettler Toledo SevenCompact S210 Mode D'emploi

4.3 Key controls
Key
Softkeys
4.4 Using the softkeys
The meter has four softkeys. The functions assigned to them change during operation depending on
the application. The assignment is shown on the bottom line of the screen.
In the measurement screen, the softkeys are assigned as follows:
Data
Access data menu
The other softkey functions are:
Move one position to the right
Move one position to the left
Scroll up in the menu
Scroll down in the menu
Increase value
Decrease value
Scroll to next data set in memory
Delete letters or numbers on
alphanumeric keypad
Delete Delete selected data
4.5 Selecting a measurement mode
Press the MODE softkey to switch between the different measurement modes.
The sequence of the alternating measurement modes is:
1. pH
2. mV
3. rel. mV
Press and release
Switch meter on
● Start or end measurement
(measurement screen)
●
Confirm input or start edit­
ing a table
● Exit menu and go back to
measurement screen
Start calibration
The function of the softkeys
varies from screen to screen
Menu
Access meter settings
Edit
End
Yes
No
Review
Save
Select
Start
Trans
Press and hold for 2 seconds
Switch meter off
Switch between measurement
close-up screen and full-infor­
mation screen
Review the last calibration data
Mode
Change measurement mode
Edit table or value
End calibration
Confirm
Reject
Review selected data
Save data, setting or value
Select the highlighted function or
setting
Begin the reference measurement
Transfer selected data
Operating the meter 15